How To Install Vinyl Floor Molding

Materials Needed to Install Vinyl Wall Base

- Enough linear anxiety of vinyl wall base, for your project. Factor in around 5-10% scrap.

- Utility knife

- Wall base adhesive

i 10 30 oz. cartridge is good for lx linear feet of base
1 x Quart of base agglutinative is good for 60 linear feet of base of operations
one x Gallon of base of operations adhesive is expert for 240 linear feet of base

- Awarding equipment, for applying base of operations agglutinative

method A - cartridge gun and snozzle (pictured)
method B - cartridge gun and spreader
method C - spreader with a tub of adhesive (either 1 quart or 1 gallon tub)

- Speed square (optional)

- Cutting surface (any scrap piece of wood)

- Wet rag

Steps to Install Vinyl Wall Base of operations

Barrel the cease of the roll upwardly to the wall.
Unroll the roll of vinyl wall base of operations the length of the wall, in club to estimate the length.
Mark where to brand your cut, but give yourself a couple extra inches.
Make a square cut.

You should at present take an unrolled length of dry out back vinyl wall base that is roughly the length of the wall.

Vinyl wall base on the ground that is the length of the wall.

Brand certain that the toe of the vinyl wall base is towards the wall with the finished side downwards, meaning the ribbed side is upwardly.

Strip of vinyl wall base with the ribbed side up and the toe of the base towards the wall.

For these instructions we will utilize the adhesive gun and the 30 oz. adhesive cartridge with the snozzle attachment.
You can accomplish the same application of agglutinative with the gun and spreader, or the spreader with a tub of agglutinative.
Puncture the agglutinative cartridge with needle on the adhesive gun.
Insert cartridge into the guy and apply the snozzle.
Begin pulling the trigger of the adhesive gun to push adhesive through the snozzle.
In one case adhesive is coming through the snozzle, we are gear up to utilize the agglutinative to the vinyl wall base. With a smoothen consistent pressure, pull the gun trigger to utilize adhesive on the vinyl wall base of operations.

Man using adhesive gun with snozzle attachment to apply adhesive to the vinyl wall base.

Slowly and steadily work your way downward the length of the wall.

Man applies adhesive to the middle of the strip of vinyl wall base.

End that down the entire length of the vinyl wall base.
Nosotros should at present take a piece of base of operations that has adhesive, side up, the unabridged length of the wall.
Go dorsum to the starting edge and brainstorm to press the agglutinative side of the base to the wall. Press firmly.

Man begins to press vinyl wall base with adhesive to the starting point of the wall.

Press firmly downward the entire length of the base.

Man continues to firmly press vinyl wall base up against the length of the wall.

Make clean up and wipe down the excess adhesive with a moisture rag.
Run the moisture rag down the unabridged length of the base.

Man runs a wet rag over the length of the wall base.

There should be some excess base of operations at the 2nd terminate of the wall. Using your speed square, cut off the excess.

Man cuts off the excess wall base with a speed square

Congrats! you lot should now have an entire wall length of vinyl wall base installed.

Finished vinyl wall base in an empty room

Now, the hard office, finish an inside corner. Cut a length of base the correct size, leaving some scrap, similar y'all did earlier in the instructions.
On the side that will brand an inside corner, use your speed square to cut the toe of the base at a 45 caste bending.